Everything below concerns AEDG. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2025-11-27. Where a claim depends on a specific study, the study is described rather than over-claimed.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
Verification of research-grade material involves comparing a supplier chromatogram against an in-house reference, checking the observed mass against the calculated value, and where possible confirming residue order by tandem mass spectrometry or enzymatic peptide mapping. Purity claims should be read alongside the method used to obtain them, because detection wavelength and integration settings alter the result. Batch-specific data, rather than a generic grade statement, is the informative part of a certificate.
Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.
| Property | Value | Notes |
|---|---|---|
| Amino acid sequence | Ala-Glu-Asp-Gly | Linear tetrapeptide, also written AEDG |
| Molecular mass | About 390.35 g/mol | Value calculated from the sequence |
| Appearance | White to off-white powder | Lyophilised material forms a loose cake |
| Solubility | Freely soluble in water | Also dissolves in isotonic saline |
| Storage | -20 °C, desiccated | Aliquot solutions to avoid freeze–thaw cycling |
Discussions in the literature often conflate three distinct entities: the pineal extract epithalamin, the isolated tetrapeptide AEDG, and commercial preparations sold under similar names. Reviews citing older Russian-language studies sometimes omit detail on purity, route of administration and control groups, which makes cross-study comparison difficult. Researchers working with the compound generally note the need for independent replication, standardized enzyme assays, and clearer reporting of peptide identity. These caveats are relevant when weighing claims that appear in secondary sources rather than in primary reports.
（TG:@pojiaai）Epitalon is a synthetic linear tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. It emerged from work on epithalamin, a peptide fraction prepared from bovine pineal tissue, and was designed as a short, chemically defined analogue of that extract. Early publications came mainly from Russian laboratories studying pineal peptides and aging-related endpoints. The compound appears in the literature under several spellings, including epithalon and epithalone, which complicates systematic searching. Its small size makes solid-phase assembly and routine analytical characterization straightforward.
Chemically, the molecule consists of four amino acid residues joined by three peptide bonds, with a free N-terminal amino group and a free C-terminal carboxyl group. Its molecular formula is C14H22N4O9, and its monoisotopic mass is approximately 390 daltons. The acidic glutamate and aspartate side chains give the peptide a net negative charge near neutral pH, a property that shapes its chromatographic behaviour and solubility profile. No disulfide bridges or other post-translational modifications are present, so the primary sequence alone defines the structure.
Freeze-dried epitalon is normally kept at minus twenty degrees Celsius in a sealed, desiccated container, protected from light. Short excursions at ambient temperature during shipping are generally tolerated, but repeated warming and cooling cycles encourage moisture uptake, which shortens shelf life. Once dissolved, the peptide is far less stable than the solid: aqueous solutions are subject to hydrolysis and to deamidation at the aspartate and glutamate residues. Working solutions are therefore held refrigerated and used within days, and repeated freezing and thawing of the same vial is best avoided.
Identity and purity are checked by reversed-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, where the peptide bond absorbs. Mass spectrometry confirms the expected mass and reveals whether truncation products or adducts are present. Acid hydrolysis followed by amino acid analysis gives the residue ratio, which should approximate one alanine, one glutamate, one aspartate and one glycine. Counter-ions such as acetate or trifluoroacetate remain in the dried product and lower net peptide content, so a stated purity figure on a label does not by itself describe how much peptide a vial holds.
Spray drying is a method of forming a dry powder from a liquid or slurry by rapidly drying with a hot gas. This is the preferred method of drying of many thermally-sensitive materials such as foods and pharmaceuticals, or materials which may require extremely consistent, fine particle size. Air is most commonly used as the heated drying medium; however, nitrogen may be used if the liquid is flammable (such as ethanol) or if the product is oxygen-sensitive. All spray dryers use some type of atomizer or spray nozzle to disperse the liquid or slurry into a controlled drop size spray. The most common of these are rotary disk and single-fluid high pressure swirl nozzles. Atomizer wheels are known to provide broader particle size distribution, but both methods allow for consistent distribution of particle size. Alternatively, for some applications two-fluid or ultrasonic nozzles are used. Depending on the process requirements, drop sizes from 10 to 500 μm can be achieved with the appropriate choices. The most common applications are in the 100 to 200 μm diameter range. The dry powder is often free-flowing. The most common type of spray dryers are called single effect. There is a single source of drying air at the top of the chamber (see n°4 on the diagram). In most cases the air is blown in the same direction as the sprayed liquid (co-current). A fine powder is produced, but it can have poor flowability and causes a lot of dust.
=== Capillary electrophoresis-mass spectrometry (CE-MS) === Capillary electrophoresis-mass spectrometry was enabled by an ESI interface that was developed and patented by Richard D. Smith and coworkers at Pacific Northwest National Laboratory, and shown to have broad utility for the analysis of very small biological and chemical compound mixtures, and even extending to a single biological cell.
Adrenaline, also known as epinephrine and alternatively spelled adrenalin, is a hormone and medication which is involved in regulating visceral functions (e.g., respiration). It appears as a white microcrystalline granule. Adrenaline is normally produced by the adrenal glands and by a small number of neurons in the medulla oblongata. It plays an essential role in the fight-or-flight response by increasing blood flow to muscles, heart output by acting on the SA node, pupil dilation response, and blood sugar level. It does this by binding to alpha and beta receptors. It is found in many animals, including humans, and some single-celled organisms. It has also been isolated from the plant Scoparia dulcis found in Northern Vietnam.
This can be done with a diverse training set including many types of ligands and receptors to produce a less accurate but more general "global" model or a more restricted set of ligands and receptors to produce a more accurate but less general "local" model.
The hypothesized existence of an RNA world does not exclude a "Pre-RNA world", where a metabolic system based on a different nucleic acid is proposed to pre-date RNA. A candidate nucleic acid is peptide nucleic acid (PNA), which uses simple peptide bonds to link nucleobases. An alternative—or complementary—theory of RNA origin is proposed in the PAH world hypothesis, whereby polycyclic aromatic hydrocarbons (PAHs) mediate the synthesis of RNA molecules. PAHs are the most common and abundant of the known polyatomic molecules in the visible Universe and are a likely constituent of the primordial sea. PAHs and fullerenes (also implicated in the origin of life) have been detected in nebulae. Some of the difficulties of producing the precursors on earth are bypassed by another alternative or complementary theory for their origin, panspermia. It discusses the possibility that the earliest life on this planet was carried here from somewhere else in the galaxy, possibly on meteorites similar to the Murchison meteorite. Sugar molecules, including ribose, have been found in meteorites.
Sources: en.wikipedia.org
The systematic names and formulas given refer to hypothetical forms in which amino groups are unprotonated and carboxyl groups are undissociated. This convention is useful to avoid various nomenclatural problems but should not be taken to imply that these structures represent an appreciable fraction of the amino-acid molecules.
Tendinopathy (tendinitis, U.S. English) is a type of tendon disorder that results in pain, swelling, and impaired function. It most commonly occurs around larger joints, including the shoulder (rotator cuff tendinitis, biceps tendinitis), elbow (tennis elbow, golfer's elbow), wrist, hip, knee (jumper's knee), or ankle (Achilles tendinitis). Causes may include trauma or repetitive activities. Less common causes include infection, arthritis, gout, thyroid disease, diabetes and the use of quinolone antibiotic medicines. Groups at risk include manual laborers, musicians, and sports participants. Diagnosis is typically based on symptoms, examination, and imaging. Typically, little inflammation remains after a few weeks, assuming that the underlying problem is related to weak or disrupted tendon fibrils. Treatment options include rest, NSAIDs, splinting, and physiotherapy. Steroid injections, surgery, or shockwave therapy may be appropriate. About 80% of overuse tendinopathy patients recover completely within six months. Tendinopathy is relatively common. Older people are most commonly affected.
Indium is produced exclusively as a by-product during the processing of the ores of other metals. Its main source materials are sulfidic zinc ores, where it is mostly hosted by sphalerite. Minor amounts are also extracted from sulfidic copper ores. During the roast-leach-electrowinning process of zinc smelting, indium accumulates in the iron-rich residues. From these, it can be extracted in different ways. It may also be recovered directly from the process solutions. Further purification is done by electrolysis. The exact process varies with the mode of operation of the smelter. Its by-product status means that indium production is constrained by the amount of sulfidic zinc (and copper) ores extracted each year. Therefore, its availability needs to be discussed in terms of supply potential. The supply potential of a by-product is defined as that amount which is economically extractable from its host materials per year under current market conditions (i.e. technology and price). Reserves and resources are not relevant for by-products, since they cannot be extracted independently from the main-products. Recent estimates put the supply potential of indium at a minimum of 1,300 t/yr from sulfidic zinc ores and 20 t/yr from sulfidic copper ores. These figures are significantly greater than current production (655 t in 2016). Thus, major future increases in the by-product production of indium will be possible without significant increases in production costs or price. The average indium price in 2016 was US$240/kg, down from US$705/kg in 2014.
Copper-free click chemistry is a bioorthogonal reaction as a variant of an azide-alkyne Huisgen cycloaddition. By eliminating cytotoxic copper catalysts, the reaction proceeds without live-cell toxicity. It was developed as a faster alternative to the Staudinger ligation with the first generation of Cu-free click chemistry, producing rate constants over 63 times faster. Although the reaction produces a regioisomeric mixture of triazoles, the lack of regioselectivity in the reaction is not a major concern for its applications in bioorthogonal chemistry. More regiospecific and less bioorthogonal requirements are best served by the traditional Huisgen cycloaddition, especially given the low yield and synthetic difficulty of synthesizing a strained cyclooctyne (compared to the addition of a terminal alkyne). The bioorthogonality of the reaction has allowed the Cu-free click reaction to be applied within cultured cells, live zebrafish, and mice. The absence of exogenous metal catalysts makes the Cu-free chemical reactions suitable for the in vivo applications of bioorthogonal chemistry or bioorthogonal click chemistry.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide. Its sequence was derived from research on peptide fractions of bovine pineal extract, and the intact AEDG sequence has not been demonstrated as an abundant free peptide in human tissue.
AEDG is the one-letter code for the four amino acids alanine, glutamate, aspartate and glycine in that order. The same molecule is written in three-letter form as Ala-Glu-Asp-Gly.
Identity is normally confirmed by mass spectrometry against the calculated mass of roughly 390.35 g/mol. Purity is then estimated by reversed-phase high-performance liquid chromatography with ultraviolet detection.
The usual approach is reversed-phase HPLC with ultraviolet detection, reported as a percentage of total peak area. Mass spectrometry is used alongside chromatography to confirm identity rather than purity alone.