en · de · es · fr · pt
epitalon-notes.peptides5388.com › Info › Epitalon Background And Discovery — 2026 Update

Epitalon Background And Discovery — 2026 Update

By Editorial Desk · published 2025-10-03 · last reviewed 2025-10-27 · Info

If you have been reading about electrospray ionisation and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.

Last reviewed on 2025-10-27. Where a claim depends on a specific study, the study is described rather than over-claimed.

Epitalon Background and Discovery

Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.

The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.

Analytical Characterization and Stability

Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.

Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.

Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.

Epitalon at a glance

PropertyValueNotes
Molecular formulaC14H22N4O9Derived from the four-residue sequence
Molar massAbout 390.35 g/molFree peptide, counter-ion not included
AppearanceWhite to off-white powderLyophilised solid from aqueous solution
Water solubilityFreely solubleShort, polar peptide chain
Common synonymsAEDG; epithaloneCatalogues use the names interchangeably

Background and Proposed Mechanism

Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. It was designed at the St. Petersburg Institute of Bioregulation and Gerontology as a short, chemically defined analogue of epithalamin, a fraction obtained from bovine pineal tissue. Small peptide bioregulators of this type formed a long-running line of work there from the 1980s onward. Because the molecule is produced by solid-phase synthesis rather than extraction, its composition is exact and its purity can be measured directly.

The most frequently cited proposed action is induction of telomerase, the enzyme that adds repeat sequences to chromosome ends. Cell-culture work from the originating group reported higher telomerase reverse transcriptase expression and measurable telomere elongation in human somatic cells after exposure. How a four-residue peptide would reach nuclear gene regulation is not established, and no cell-surface receptor or uptake route has been identified. Additional reports describe changes in melatonin secretion, antioxidant enzyme activity and lipid peroxidation in aged animals, but these findings remain mechanistically unconnected to the telomerase observation.

Related pages on this site

Analytical Verification and Storage

The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.

No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.

Structure, Naming and Discovery

Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.

The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.

Residue composition is the property that most cleanly separates verified material from mislabelled samples. Alanine, glutamate, aspartate and glycine appear in that order from the N-terminus, and the two acidic residues sit in the middle of the chain. Because the peptide is short, it can be produced by solid-phase synthesis and characterised by mass spectrometry without ambiguity. Any reported sample whose measured mass departs substantially from 390 daltons is a different compound or a degraded mixture rather than epitalon.

Analytical Methods and Storage

Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.

Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.

Verification of research-grade material involves comparing a supplier chromatogram against an in-house reference, checking the observed mass against the calculated value, and where possible confirming residue order by tandem mass spectrometry or enzymatic peptide mapping. Purity claims should be read alongside the method used to obtain them, because detection wavelength and integration settings alter the result. Batch-specific data, rather than a generic grade statement, is the informative part of a certificate.

Background from the literature

=== Government === Official U.S. Government web portal – gateway to government sites House – official website of the United States House of Representatives Senate – official website of the United States Senate White House – official website of the president of the United States Supreme Court – official website of the Supreme Court of the United States

ENvue is an advanced electromagnetic navigation system for enteral feeding tube placement. The system uses a field generator and several EM sensors enabling proper scaling of the display to the patient's body contour, and real-time view of the feeding tube tip location and direction, which helps the medical staff ensure correct placement and avoid placement of the tube in the lungs. 3D printing is another major development in healthcare. It can be used to produce specialized splints, prostheses, parts for medical devices and inert implants. The end goal of 3D printing for some individuals is being able to print out customized replaceable body parts. In the following section, it will explain more about 3D printing in healthcare. New types of technologies also include artificial intelligence and robots.

Common side effects of high-dose CPA in men include gynecomastia (breast development) and feminization. In both men and women, possible side effects of CPA include low sex hormone levels, reversible infertility, sexual dysfunction, fatigue, depression, weight gain, and elevated liver enzymes. At very high doses in older individuals, significant cardiovascular complications can occur. Rare but serious adverse reactions of CPA include blood clots, and liver damage. CPA can also cause adrenal insufficiency as a withdrawal effect if it is discontinued abruptly from a high dosage. CPA blocks the effects of androgens such as testosterone in the body, which it does by preventing them from interacting with their biological target, the androgen receptor (AR), and by reducing their production by the gonads, hence their concentrations in the body. In addition, it has progesterone-like effects by activating the progesterone receptor (PR). It can also produce weak cortisol-like effects at very high doses. CPA was discovered in 1961. It was originally developed as a progestin. In 1965, the antiandrogenic effects of CPA were discovered. CPA was first marketed, as an antiandrogen, in 1973, and was the first antiandrogen to be introduced for medical use. A few years later, in 1978, CPA was introduced as a progestin in a birth control pill. It has been described as a "first-generation" progestin and as the prototypical antiandrogen. CPA is available widely throughout the world. An exception is the United States, where it is not approved for use.

Sources: en.wikipedia.org

Further detail

The 1988 US presidential elections lent new urgency to the negotiations, which had recently stalled after six consecutive rounds of talks in Brazzaville. Angola and Cuba had gambled heavily on a victory for Michael Dukakis and the Democratic Party during the US elections, hoping that this would spell the end of US aid to UNITA and a harder line on South Africa. At the time of the Geneva Protocol, dos Santos had commented that "if the Democrats had won the elections, there would be a readjustment in US policy, particularly on Southern Africa". The election of Republican candidate George H. W. Bush had the effect of persuading the Angolan and Cuban delegations to be more flexible. Crocker reiterated on several occasions that a new US administration meant changes in personnel and basic policy review, and pressed them not to waste months of effort. Three days after the US election results were released, the parties reconvened in Geneva and within the week had agreed to a phased Cuban withdrawal over the course of twenty seven months. In exchange, South Africa pledged to begin bestowing independence on South West Africa by 1 November 1989. On 13 December 1988, South Africa, Angola, and Cuba signed the Brazzaville Protocol, which affirmed their commitment to these conditions and set up a Joint Military Monitoring Commission (JMMC) to supervise the disengagement in Angola. The JMMC was to include Soviet and US observers. All hostilities between the belligerents, including PLAN, were to formally cease by 1 April 1989.

nuclease Any of a class of enzymes capable of cleaving phosphodiester bonds connecting adjacent nucleotides in a nucleic acid molecule (the opposite of a ligase). Nucleases may nick one strand or cut both strands of a duplex molecule, and may cleave randomly or at specific recognition sequences. They are ubiquitous and imperative for normal cellular function, and are also widely employed in laboratory techniques.

Hyperinsulinemic hypoglycemia describes the condition and effects of low blood glucose caused by excessive insulin. Hypoglycemia due to excess insulin is the most common type of serious hypoglycemia. It can be due to endogenous or injected insulin.

Sources: en.wikipedia.org

Frequently asked questions

What is epitalon made of?

It is a synthetic tetrapeptide built from alanine, glutamate, aspartate and glycine. The four residues are joined by standard peptide bonds, giving a linear chain rather than a branched structure.

Why is it called epitalon?

The name derives from epithalamin, a pineal gland extract studied in the former Soviet Union. Researchers proposed that short fragments of that extract carried the biological activity of interest.

Is epitalon approved for medical use?

No major regulatory agency has approved it as a medicine. It is handled as a research chemical, and products sold under this name are not standardised drugs with defined clinical labelling.

Why is ultraviolet detection at 214 nanometres used?

The molecule lacks aromatic residues, so it absorbs weakly near 280 nanometres, the wavelength applied to many other peptides. The peptide bond absorbs strongly below 220 nanometres, making 214 nanometres a practical compromise. Gradient methods must therefore use mobile phases with low ultraviolet absorbance to keep the baseline clean.

Network